Da-Lite: Product Specifications

Executive Electrol

Specification Data

Installation Manual

Specification CAD File (*.dxf)

When Ordering Make Appropriate Selections:

1. Select size:

Use our handy chart(s) on the CAD Drawing Page.

2. Select Viewing Surface

3. Select Method Of Installation

Type 1 and 2 (Flush or Offset Mounting).
Type 3 (Extended Mounting).

4. Options

Black “Extra Drop” to lower picture area more than normal. Maximum total drop 20' including picture area.
White “Extra Drop” to lower picture area more than normal. Maximum total drop 20' including picture area.
Single Motor Low Voltage Control, 3 Button with 1 Switch
Radio Frequency Wireless Remote Control for LVC System
Infrared Wireless Remote Control for LVC System
Locking Switch Coverplate for 120 V or 3 Button LVC Switch.
Key Operated Switch for 120 V only (note: cannot be used with low voltage system).
No borders (black masking borders standard).
220 Volt (50 Hz) Motor.
Video Projector Interface - 12 V or 5 V.

5. Features

Top of the line, heavy-duty electric screen
Install in-the-ceiling with cam operated door to conceal screen between uses
Doors may be finished to match ceiling

6. Suggested Specifications

__________ projection screens, __________ (H) x __________ (W), electrically operated 120 volt (60 Hz), 2.5 amp. Three wire quick reversal motor especially designed for the purpose, to be ball bearing and oiled for life. With automatic thermal overload cutout and integral interlocking gears. To have preset but accessible limit switches to automatically stop picture surface in the “up” and “down” positions. Stop action to be positive to prevent coasting. Rigid metal roller at least 3" in diameter (to be used on screens up to 10' in width) or 5 3/4" in diameter (on screens 12' and over in width. Roller to be mounted on two cast aluminum brackets equipped with self-aligning bearings. Screen fabric to be flame retardant and mildew resistant fiberglass with Glass Beaded, High Power or Matte White picture surface with black masking borders standard. Case to be of wood, with double top for extra rigidity and sound deadening. Motor compartment to be metal lined. A section of the bottom of the case shall be equipped with hinges and connected to the drive mechanism so that it opens and closes automatically with the lowering and raising of the screen surface. Balance of the bottom panel shall be pegged to manual opening to provide access and shall be mounted to allow matching of the bottom panel to the ceiling. Specify Type 1 and 2 or Type 3 hinge, as required. Case to be finished with a primer coat ready to accept final finish by others. To be complete with three position control switch in box with cover plate. Screen to be listed by Underwriters' Laboratories.

Matte White: Seamless in all standard sizes.

Glass Beaded: Will be seamless up to and including 8'

High Power: Available in sizes up to and including 9' x 12'. Will be seamless up to and including 6'.